REPTOR 3D Printer Nozzle Cleaning Kit
Stainless Steel Nozzle Cleaning Tool Kit Alternative, Drill Bits, 3D Printer Nozzle Cleaning Kit, Sharp Quality Tweezers, Sturdy High Quality Stainless Steel Nozzle, 3D Printer Set
What We Like
- Anti-static tweezers help in maintaining nozzle and cleaning excess support material
- Comes in a neat plastic tube with a screw lid that keeps the items safely together
- Remove excess plastic and clear jams with high precision that makes it long-lasting
- may take time to remove clog
Results of our analysis:
We analyzed 8,770 reviews for 71 products in the 3D Printer Accessories category.
We analyzed a total of 85 reviews for this product. Of these, 7 reviews were recent.
Around 88% of reviews were positive and about 8% were negative.
9.80 out of 10, based on these 9 factors:
What buyers say about REPTOR 3D Printer Nozzle Cleaning Kit
If you are new to 3d printing you will need this kit, it's smaller than a sewing needle and you need the acupuncture needles to clear a toy or clogs.
The packaging is great, and the cups of tools I keep by my printer are also great.
The kit was recommended by customer support at Ultimaker after they tried multiple hot & cold pulls to clear the nozzle.
The Bibo 3 printer is easy to clean thanks to the extra long needles that go from the top to the bottom of the assembly, and I gave it 3 stars for that.
If you want to get the best result, preheat the nozzle, insert one of the pins, remove the plastic that sticks to the pin, and then repeat several times until the pin goes in easily.
What is the length of the needle?
3” and seem flexible enough to angle into a clog from the lower end or long enough for an upper approach.
Your title says "Drill Bit" but your pictures show needles. Which is it?
It should read "needles" as in the description, which is fixed.
Is it possible to use this product on any 3d printer?
a small family business we really care for product quality and 100% overall customer satisfaction at all times so if there's anything we can ever assist you with, anything at all, please know. Thank you so much for your interest in the Reptor tools, as a small family business we
Are the instructions on how to use it?
You should not need instructions if you heat the printer up to temp and use the needles to try to remove the gunk from the nozzle.
What type of glue stick is used to adhere to glass?
I use blue painter tape instead of normal glue sticks and it is less messy.