Home > 3D Printer Accessories > 3D Printer Parts Ender 3 Hotend Assembled Ender 3 Pro Extruder Kit 24V 40W for Creality Ender 3 / Ender 3 Pro/Ender 3 V2 with Silicon Cover and 0.4mm Nozzles ; Brand: RICHOOSE

RICHOOSE 3D Printer Parts Ender 3 Hotend Assembled Ender 3 Pro Extruder Kit

Assembly Kit, Pro Extruder Kit, V 40W, Creality Ender 3 / Ender 3 Pro Ender 3 V2 With Silicon Cover And 0.4Mm Nozzles

7.3
Created with Raphaël 2.1.27.3010
H&F Rating 50 reviews
All Buying Options
Add to Wishlist
$1 OFF

 on Amazon

Get it on prime

Products Similar to RICHOOSE 3D Printer Accessories

Results of our analysis:

img-alt

We analyzed 8,770 reviews for 71 products in the 3D Printer Accessories category.

img-alt

We analyzed a total of 50 reviews for this product. Of these, 10 reviews were recent.

img-alt

Around 48% of reviews were positive and about 50% were negative.

Final Score:

img-alt

7.32 out of 10, based on these 9 factors:

  • Durability
  • Easy to install
  • Easy to use
  • Overall satisfaction
  • Packaging
  • Quality of material
  • Size
  • Sturdiness
  • Value for money
  • What buyers say about RICHOOSE 3D Printer Parts Ender 3 Hotend Assembled Ender 3 Pro Extruder Kit


    It wasn't as hard as I had thought it to be, and you should check your assembly manual for the model you're buying to make sure it's 24v.


    I had some old filament ruin my hot end, so I got a bunch of wiring, and a pack of spare nozzles, we were big pluses. I just switched to PETG, and still have some configuration work to do to fix.


    I have been using the Ender 3 for a few weeks now and I have to say, it is a very easy to use and easy to clean tool to use.


    The whole assembly was a direct replacement for the original, and all the wires were the correct length.


    One reviewer says there is a missing part, but it's not a hotend.

    Common Questions

    Q:

    Is this compatible with the Ender 3 Pro V2?

    A:

    The hot end doesn't work with ender 3 V2.

    Q:

    I don't know if this comes pre-wired at the opposite end of the extruder.

    A:

    The heater ends in bare wires, usually attaching to a terminal block.

    Q:

    Is this work for the Ender 5?

    A:

    This does not work for the ender 5 so please purchase the Ender 5 parts from the link below.

    Q:

    How hot can the end get?

    A:

    The maximum temperature is between 240C and 250C.

    Q:

    Will this fit the geeetech a10?

    A:

    Also, the heater block attachment holes are slightly offset from the extruder hole on this one, and on the Geeetech they're all inline.

    Do you like this review?