All Categories
AMX3d PTFE Teflon Bowden Tube
Extruder White Connector Tubing, Amx3D Ptfe Teflon Tube, 1.0 Mm Id 4.0 Mm Od, A More Stable Seal
Products Similar to AMX3d 3D Printer Accessories
Results of our analysis:
We analyzed 9,770 reviews for 71 products in the 3D Printer Accessories category.
We then analyzed 49 reviews for this product. Of these, 7 reviews were recent.
Around 76% of reviews were positive and about 20% were negative.
Final Score:
8.56 out of 10, based on these factors:
What buyers say about AMX3d PTFE Teflon Bowden Tube
It's good to have a little extra on hand to make sure I'm able to replace the worn out tube in my 3d printer.
I got my F410 printer back in action, and it's much better than the $30 tube from the original manufacturer.
The tube is the same size and performance as my printer, and the price is right.
Good quality grade PTFE for 3D printer feed tubes.
I got my F410 printer back in action, with enough material for another, and it was much better than the $30 tube from the original manufacturer.
Common Questions
I don't know if this will work for my bio printer, it had a filament break in between the extuder piece, I don't know if it will work for my other printer.
If it doesn't work, try capricorn tubing, it's for all printers.
Is it possible to use this to replace the ptfe in my hot ends?
It's possible, just have to trim carefully to length, and you might want to make a little station so you cut the same each time.
Will this work after I lost the ptfe?
It's possible to add a little bevel to the ends, which helps make sure the tube is guided into the tube, instead of hitting the edge and getting jammed.
Why is this listing using other people's photos of ptfe tubing, but not the actual product?
If this is your photo, we have removed it from our listing and will replace it, but please know that we did send our products out to be photographed for our listings at the time this photo was taken.
I don't know if Teflon tubing keeps the inside of the tube cooler than the outside.
This is to replace the stock tubing on 3D printers.It is a little larger inside so your filament travels easier. If you are having problems with your Extrusion rate skipping or not a continuous flow replacing this to on your printer should help tremendously.
Continue with Google
