All Categories
Authentic Capricorn Bowden PTFE Tubing XS Series 1 Meter
High Strength Steel Alloy, 2X Pc4-M10 Hotend Fitting, 1.75 Mm Filament, Pc4-M6 Extruder Fitting, Authentic Capricorn Bowden Ptfe Tubing Xs Series
Products Similar to Mefine 3D Printer Accessories
Results of our analysis:
We analyzed 9,770 reviews for 71 products in the 3D Printer Accessories category.
We then analyzed 65 reviews for this product. Of these, 22 reviews were recent.
Around 74% of reviews were positive and about 20% were negative.
Final Score:
9.07 out of 10, based on these factors:
What buyers say about Authentic Capricorn Bowden PTFE Tubing XS Series 1 Meter
The son who is 12 years old has been using this for his 3-D prints and he says it has made them better. The only issue we had was that the included wrench wouldn't work on the printer end and we had to use a different wrench.
I use a low quality tube for my cligging and I have not had any issues with it since I dropped a 30mm piece of this in the hotend.
Good quality, fits the 1.75mm filament much tighter, allowing for better control of hot end extrusion.
It was much better than the stock that comes with it and it was easy to install and feed the 3d printer.
It is a must to get a clean cut and good deal at both ends of the tube with the great upgrade and tube cutter.
Common Questions
Shouldn't this tubing be 1.95mm x 4mm instead of 1.95mm x 2mm?
The exterior diameter is 4mm.
Is this product compatible with the monoprice mp 10?
Yes. If you are using any 1.75mm filament, it will improve most of your prints.
Where is this product shipped?
The mine was shipped from the US.
Will this work with my Ender 3 Pro?
If you are using a Bowden extruder, there are several sized push fittings that will fit the ender.
Shouldn't this tubing be 1.95mm x 4mm instead of 1.95mm x 2mm?
The exterior diameter is 4mm.
Continue with Google
