Fulament Fula-Flex 2.0 Textured/Smooth Double Sided PEI Flex Plate 220mm x 220mm for 3D Printing
A Plastic Housing, Your 3D Printing, 2.0 Textured Smooth Double Sided Pei Flex Plate, Magnetic Sticker
Results of our analysis:
We analyzed 9,770 reviews for 71 products in the 3D Printer Accessories category.
We then analyzed 96 reviews for this product. Of these, 13 reviews were recent.
Around 65% of reviews were positive and about 25% were negative.
8.68 out of 10, based on these factors:
What buyers say about Fulament Fula-Flex 2.0 Textured/Smooth Double Sided PEI Flex Plate 220mm x 220mm for 3D Printing
This upgrade has been an awesome one, not only because of the fact that it requires a bit of care during installation, but also because of the fact that it allows you to print larger amounts of material at a time, without having to use clips to hold the print surface to the heated bed
If you don't know, printing petg will stick to PEI and you need to use a releasing agent like Windex or Glue stick to prevent damage.
I have been using my Fula-Flex for a few months now, and I have to say that it is a very good printer. I have not had any issues with it at all, and it is very easy to use.
I like the Fulament Fula-Flex 2.0 Smooth Side PEI Flex Plate and have raised the rating to 3 stars.
I have used many sheets including glass and creality own PEI sheet for my pro's and I feel this is a great quality and I was a bit worried at first but it worked great for my Ender 3 pro's.
I have an ender 3 v2 that is 220x 220 and it seems short when placed on the bed, is it normal?
I returned it for a new one because it didn't fit on my ender 3 pro.
Will my level sensor work with this?
I have a BLTouch and work well, but you may have to adjust your Z-offest to account for the PEI layer.
What is the thickness of the PEI on this?
The metal part is 0.026 inches and the magnet part is 0.044 inches.
Does this work with petg? What needs to be done to make it work well and last?
I use glue stick. It's good for pets and people. To clean it, just use hot water and glue stick.
Is it possible to attach this to my heated bed using binder clips?
If you don't use the glue you will have to get some gunk gone to get it cleaned up again, but I recommend taking the plunge and using it as intended.