All Categories
HICTOP 100K ohm NTC 3950 Thermistors/Temp Sensor for Reprap Creality Ender 3, Ender 3 Pro, CR-10 10S 3D Printer
A 3D Printed Model, Thermistors Ntc 3950 Thermistorstemp Sensor, Repreality Creality Ender 3, The Hictop Store
Products Similar to HICTOP 3D Printer Accessories
Results of our analysis:
We analyzed 9,770 reviews for 71 products in the 3D Printer Accessories category.
We then analyzed 41 reviews for this product. Of these, 17 reviews were recent.
Around 37% of reviews were positive and about 61% were negative.
Final Score:
7.08 out of 10, based on these factors:
What buyers say about HICTOP 100K ohm NTC 3950 Thermistors/Temp Sensor for Reprap Creality Ender 3, Ender 3 Pro, CR-10 10S 3D Printer
A spot of hot glue between the plug and another plug will prevent that.
I want to light the whole thing on fire and make it explode with a sledgehammer. I upgraded my rating to 4 stars since these work just fine.
The most difficult part of installing this is getting the old one out of the sleeve and fishing this one through the sleeve, as I used it to replace the the thermistor on my 3 Pro.
I ordered the temp sensors for the Ender 3 Pro but they were too short.
I caught it before it damaged my board, but it's possible that you will damage it if you don't take precautions.
Common Questions
What is the temperature range like on these?
They are good up to 300C, but anything higher needs a thermocouple.
What are the the thermistor's key information, including the manufactuer and table id?
But you have to dp your research on Marlin fw settings of the hictop 3 d printer.
Is the correct thermistor for the original prusa i3 mk2s heat bed?
Yes. It can fit for the prusa i3 mk2s heat bed.
Will it work with the robo 3d r1?
Yes, it did for me and there were no problems at all.
What is the size of the jst connectors?
I had to replace the old one on my anet a8.
Continue with Google
