Home > 3D Printer Controllers > BIGTREETECH TFT35 E3 V3.0 Graphic Smart Display Controller Board for Creality Ender 3 Compatible with SKR Mini E3, SKR V1.4 Turbo, SKR E3 Turbo, SKR Pro V1.2 Motherboard ; Visit the BIGTREETECH Store

BIGTREETECH TFT35 E3 V3.0 Graphic Smart Display Controller Board

Arm Processor, Tft35 E3 V3.0 Graphic Smart Display Controller Board, Net Framework, Supports Windows, The Bigtreetech Store, 2 Gb Ram, The Bigtreetech Display Controller Board

H&F Rating 90 reviews
Add to Wishlist
$10 off

 on Amazon

Get it on prime

What We Like

  • Comes with an SD card that makes firmware upgrade easy
  • Features a 3Reserve Wi-Fi port and an external WI-FI module that realizes the extension port of filament breaking detection
  • Automatic shutdown feature makes it easy to use


  • Screen may get stuck sometimes

Results of our analysis:

We analyzed 2,350 reviews for 13 products in the 3D Printer Controllers category.

We then analyzed 90 reviews for this product. Of these, 65 reviews were recent.

Around 53% of reviews were positive and about 47% were negative.

Final Score:

7.85 out of 10, based on these factors:

  • Durability
  • Tech support
  • Value for money
  • Touch control
  • Customer support
  • Overall satisfaction
  • Build quality
  • Noise level
  • Easy to install
  • What buyers say about BIGTREETECH TFT35 E3 V3.0 Graphic Smart Display Controller Board

    There are many features, including the ability to swap between the graphic interface and the old classic, which is something that has never been done before with a mainboard with a bigTREETECH SKR 2 Rev B mainboard.

    The screen space is large, and I need to mount it to my printer in order to use it.

    It was installed with BTT skr V2 and ESP, 5 x TMC2209 drivers, a screen with 3D Touch, and a modified version of the Marlin 2.0.9 software on the Artillery Sidewinder X1

    The menu and the firmware are nice. If you need another version of the Firmware, you can pull it from the repository and install it too.

    The new touchscreen is great and I like the fact that you can change the interface from the old one to the new one.

    Common Questions


    I have a tft35 v 3.0 that has a knob attached to it, what is the best way to remove it from the screen?


    Pull it.


    Does this work with the ender 5 pro silent board or does I need the big treetech board as well?


    The screen can be used with stock boards, you don't need a BTT mainboard.


    Will it work with SKRv1.3 board?


    It can be hard to get to work, but it will.


    Is the print failure problem the same as the tft35 v3.0?


    I have only run into the overheating x axis driver, and Amazon replaced it immediately.


    Why raise the price over 2 dollars a day?


    There is supply and demand.

    Do you like this review?