Home > 3D Printer Extruders > Hardened Steel Nozzle 0.4 mm/ 1.75 mm 3D Printer MK8 Nozzles Tool High Temperature Wear Resistant Compatible with Makerbot, Creality CR-10 All Metal Hotend, Ender 3/ Ender3 pro, Prusa i3 (5 Pieces) ; Visit the Mudder Store

Hardened Steel Nozzle 0.4 mm/ 1.75 mm 3D Printer MK8 Nozzles

100 % Satisfaction Or Money Back Guarantee, High Temperature Wear Resistant, Hardened Steel Nozzle, All Metal 3D Printer, Creality Cr 10 All Metal Hotend

7.1
7.1010
H&F Rating 71 reviews
Add to Wishlist

Products Similar to Mudder 3D Printer Extruders

Results of our analysis:

We analyzed 3,286 reviews for 20 products in the 3D Printer Extruders category.

We then analyzed 71 reviews for this product. Of these, 41 reviews were recent.

Around 41% of reviews were positive and about 55% were negative.

Final Score:

7.08 out of 10, based on these factors:

  • Accuracy
  • Build quality
  • Compatibility
  • Design
  • Durability
  • Easy to install
  • Overall satisfaction
  • Size
  • Sturdiness
  • Value for money
  • What buyers say about Hardened Steel Nozzle 0.4 mm/ 1.75 mm 3D Printer MK8 Nozzles


    It was in a five pack and should last for quite some time.


    I put one of these bad boys on and set the temp up to 10 degrees higher because they are steel.


    I bought these to try out some of the nozzles I use on my Creality CR-10 and they are just as easy to install as the ones I use in a brand new nozzle.


    These steel nozzles are great for printing at higher temperatures, and will not cause jams if you print at 20c.


    I had to increase my width to 125% to try to print decent, and I did that by tweaking the PID and changing the Z offset.

    Common Questions

    Q:

    I bought these for my ender 3 pro, they won't print without messing up, what is wrong with them?

    A:

    If these are not the size that you are told to be, I would recommend getting a refund.

    Q:

    Is it compatible with the bibo 3d printer?

    A:

    I can't say 100%, but if you search it, it says they are compatible.

    Q:

    I have tried a 7mm as suggested for the standard size nozzle but that slips and a 6 is to small. What size sockets do I use to remove this?

    A:

    I used the little tool that came with my printer to use the screw driver.

    Q:

    Is it possible that it works with the snapmaker?

    A:

    It works well on the Ender 3 v2.

    Q:

    I bought these for my ender 3 pro, they won't print without messing up, what is wrong with them?

    A:

    If these are not the size that you are told to be, I would recommend getting a refund.

    Do you like this review?