WINSINN Dual Gear Extruder, Compatible with Ender 3
The Original Motor Shaft, The Winsinn Dual Gear Extruder, 3D Printer 1.75Mm Filament, Aluminum Drive Feed
Results of our analysis:
We analyzed 3,286 reviews for 20 products in the 3D Printer Extruders category.
We analyzed a total of 473 reviews for this product. Of these, 351 reviews were recent.
Around 37% of reviews were positive and about 57% were negative.
7.75 out of 10, based on these 10 factors:
What buyers say about WINSINN Dual Gear Extruder, Compatible with Ender 3
If you don't have everything you need before you pull the old gear off, you're going to be without a printer.
You can find a lot of guides to help with the process of calibrating your extruder, but I would not recommend setting e-steps to a number someone else told you to set it to, and then running the calibration yourself.
The dual gear extruder is easy to install and it does not try to crush the filament after many moves.
If I had been more careful in my ordering, I wouldn't be here, I bought this er to use at work with my Elegoo Neptune 2s being my home work horse.
I have been using this extuder for a couple of weeks now and I have to say that it is pretty easy to use and easy to set up.