Home > 3D Printer Platforms > Dawnblade Creality Ender 3 Glass Bed Upgraded, 235x235x4mm ; Visit the Dawnblade Store

Dawnblade Creality Ender 3 Glass Bed Upgraded

No Edge Curling 3D Printer Coated Glass Bed, 3D Printing, A Necessary 3D Printing

8.6
Created with Raphaël 2.1.28.6010
H&F Rating 364 reviews
Add to Wishlist
$3 OFF

 on Amazon

Get it on prime

What We Like

  • Improved 3D printer glass plate provides more flat and more smooth build surface than magnetic mat or pei sticker
  • Comes with middle sized clips that makes it easy to take off the model
  • Compatible with Creality 3D printer Ender-3, Ender-3 Pro, Ender-3S, and more

Disadvantages

  • may not be easy to get prints to stick

Products Similar to Dawnblade 3D Printer Platforms

Results of our analysis:

img-alt

We analyzed 2,635 reviews for 21 products in the 3D Printer Platforms category.

img-alt

We analyzed a total of 364 reviews for this product. Of these, 265 reviews were recent.

img-alt

100% of reviews were positive.

Final Score:

img-alt

8.62 out of 10, based on these 8 factors:

  • Easy to remove
  • Size
  • Adhesion
  • Durability
  • Easy to install
  • Overall satisfaction
  • Quality of material
  • Value for money
  • Common Questions

    Q:

    Will the Z-axis stop switch need to be adjusted since the glass is thicker than the mag sheet?

    A:

    It definitely will, but start by cranking down the bed springs all the way. Make your adjustments from there and then back off the springs as little as possible.

    Q:

    Is it necessary to change the bed level when you switch from pla to abs or does the glass not expand as much between the changes in temperature?

    A:

    I don't think it's necessary to adjust the bed level because the material of the hot bed is borosilicate glass, which has a very low thermal expansion coefficient, about one-third that of ordinary glass, and its shape deviation is very small.

    Q:

    Is it possible to remove the plastic sheet over the top of the textured glass surface?

    A:

    The surface with coating is covered with a plastic film. Remove this plastic film before use.

    Q:

    The top part that has the coating on it worked amazingly for 15 prints, but then it stopped sticking completely everywhere. Any solution?

    A:

    I have found that giving the bed a quick wipe with 70% isopropyl alcohol solution will clean the bed, dry quickly, and leave the bed slightly tacky, but still allow prints to lift off easily.

    Q:

    What is the difference between this and the boro plate that came with my Ender 3 V2?

    A:

    far as I can tell, it is the same.

    Do you like this review?