All Categories
Gizmo Dorks PEI Sheet 3D Printer Build Surface
Gizmo Dorks 3D Printer, Pre Applied Laminated 3M 468Mp Adhesive, Build Surface, Creality Ender 3
What We Like
- Installs quickly via the laminated adhesive on top of existing flat build platforms
- 3M 468MP adhesive is preapplied that offers quick adhesive to the bed
- Comes with 0.56mm thickness that fits the Creality Ender 3 or Creality CR 20 perfectly
Disadvantages
- Adhesive may be way too strong
Products Similar to Gizmo Dorks 3D Printer Platforms
Results of our analysis:
We analyzed 2,635 reviews for 21 products in the 3D Printer Platforms category.
We then analyzed 90 reviews for this product. Of these, 68 reviews were recent.
100% of reviews were positive.
Final Score:
9.56 out of 10, based on these factors:
Common Questions
Is there a glue that I need to use for the filament stick?
The first thing I do when installing a new PEI sheet is to evenly rough up the entire surface with 360 grit sandpaper, scratching in multiple.
I want to replace my sheet with a new one because there is a low point in the middle of the bed.How do I get rid of it?
You can easily remove the broken down glue with a hard flat surface after a few coats of the 3M 08987 adhesive remover.
How can I get the bubbles out of under it?
It won't affect operation unless it's a big bubble. The clips were gone from underneath where they were used to hold this PEI to a heat-bed, so perhaps a press could do it, or a vacuum pump.
Is the textured side the print side or the glossy side that will face up when installed?
You remove the kraft paper that protects the adhesive and stick the adhesive side down to the bed.
If it isn't making round circles, what can I do?
Not quite enough info to answer, can be caused by not specifying enough facet counts in the design program.
Continue with Google
