Comgrow COMGROW Creality Fireproof and Dustproof 3D Printer Enclosure Mini 3D Printer Tent
Creality Fireproof, A Constant Temperature Printing Environment, This 3D Printer Enclosure, The Printing Room, 3D Printer Enclosure Mini 3D Printer Tent
Results of our analysis:
We analyzed 57,099 reviews for 193 products in the 3D Printers category.
We then analyzed 131 reviews for this product. Of these, 42 reviews were recent.
Around 65% of reviews were positive and about 28% were negative.
8.87 out of 10, based on these factors:
What buyers say about Comgrow COMGROW Creality Fireproof and Dustproof 3D Printer Enclosure Mini 3D Printer Tent
I added that assembly was very easy, it did help contain smells, and I noticed a newer review about the size, which made me realize it is not much bigger than the Ender 3.
I don't use it right now, as it isn't needed for PLA in a heated room, and I'll bring it into the cooler basement workshop for ABS and other filaments.
I think assembly is very easy, it does help contain smells, and I noticed a newer review about the size, so I added that it is not much bigger than the Ender 3.
This is a good product for its price and it is well suited for its purpose and easy assembly. My only wish is that there be more options for wires to enter and a grid or panel for mounting extras inside.
This is a small printer that fits in a pocket and is easy to assemble, and it has done a great job of keeping my cats from jumping onto the printer.
Do you have any videos of it putting out a printer fire?
A camping tent that is fire-treated will still burn even though the flame has stopped. If you need true fireproof, you want an all-metal enclosure and you want to relocate the power supply outside the enclosure.
Will the window's wrinkling get better over time?
Would a small heater in the printer enclosure be necessary if it was in a cold room with AC on?
You don't need the heater, just give enough time to preheat.
Is the small enclosure compatible with an Anycubic Photon printer?
The CR-10s are small enough to fit in the small.
I want to run my tube from the left side, but I don't know if there are any openings to do it. Will I have to make one?
I don't recommend it, my printer melted when I put it in the enclosure.