Kingroon 3D Printers Premium Titan Extruder Aluminum Double Linear Guide Rails and Double Cooling Fans
Results of our analysis:
We analyzed 57,099 reviews for 193 products in the 3D Printers category.
We then analyzed 89 reviews for this product. Of these, 21 reviews were recent.
Around 52% of reviews were positive and about 29% were negative.
8.93 out of 10, based on these factors:
What buyers say about Kingroon 3D Printers Premium Titan Extruder Aluminum Double Linear Guide Rails and Double Cooling Fans
The cost of $170 is a steal and the printer is easy to assemble, 4 screws and its ready.
The 40mm to 30mm duct for the hot end is just what you need for that job, and there is also better part cooling around as the one included is pretty feeble, but does the job.
The Robin Nano v1.2 is a 32 bit clone of the popular Kingroon printer and it is better than the stock Ender 3s and 5s controller boards which are only 8bit.
The pre-wired PSU is a nice touch and much safer than other ones I have used before. The spool holder is better than some other ones I had, and it was included.
bullet points include: easy to set up, easy to learn, cheap, and quality, and this thing is built like a tank.