All Categories
ELEGOO 3D Printer Resin LCD UV-Curing Resin 405nm Standard Photopolymer Resin
Elegoo 3D Printer Resin Lcd Uv Curing Resin 405Nm Standard Photopolymer Resin, 3D Printing Grey 500G, Low Shrinkage Elegoo Photopolymer Resin, High Precision Elegoo Photopolymer Resin
Products Similar to ELEGOO 3D Printing Liquid
Results of our analysis:
We analyzed 8,088 reviews for 46 products in the 3D Printing Liquid category.
We then analyzed 315 reviews for this product. Of these, 60 reviews were recent.
Around 64% of reviews were positive and about 30% were negative.
Final Score:
8.27 out of 10, based on these factors:
What buyers say about ELEGOO 3D Printer Resin LCD UV-Curing Resin 405nm Standard Photopolymer Resin
I've read that you can cure your parts while they are submerged in water, but I haven't personally tested this, and the Elegoo resin has a great, hard surface finish that I was expecting from the grey.
I have spent a lot of money on printer repairs due to the recent purchase of Mars. I decided to try a different brand after my latest screen replacement and that brand printed perfectly.
If you are new to 3, I would recommend the Elegoo Mars printer and the Elegoo resin. I have shown my associates some of the projects that I have been able to print and they cannot get over the details that I am able to print.
It did what I wanted it to, the print quality is good, but I have to make improvements to it to be better.
I use a lot of alcohol for the wash fluid, but I wouldn't recommend it for standard minifigure prints.
Common Questions
Where can I find the material data sheet?
The Resin Parameter is Hardness: 84 D; Shrinkage: 7.1 %V iscosity: 150-200 mPa.sL; olid Density: 1.195 g/cm3F lexure Strength: 59.
I noticed there wasn't a seal on the opening of the bottle when I opened it for the first time.
I have never had a seal on the bottle opening and as long as the plastic bag is not tampered with/ripped open it should be fine.
Is it possible to use this in an oyumaru mold and cure it with a UV lamp?
It won't work for casting because the cured resin doesn't transmit UV well and it gets hot when curing.
I'm learning how to recycle, but I'm not sure if it's possible after the resin cures.
I don't know of any methods of recycling it, at least not the way that you can in some instances recycle scrap from an FDM printer.
I'm not sure why my prints keep cracking, has anyone else had this problem solved?
If you cure one side longer than the other, it can cause stress on the under cured side, and cause it to crack.
Continue with Google
