All Categories
DEWALT Wire Wheel, Cable Twist, 4-Inch (DW4930)
Reduced Knot Movement, Steel Wire, The Wire Wheel, Internal Holding Plate Construction, 4 Inch, Heat Treated Carbon Or Stainless Steel Wire, High Tensile
Products Similar to DEWALT Abrasive Wheel Brushes
Results of our analysis:
We analyzed 2,364 reviews for 15 products in the Abrasive Wheel Brushes category.
We then analyzed 309 reviews for this product. Of these, 243 reviews were recent.
100% of reviews were positive.
Final Score:
9.66 out of 10, based on these factors:
What buyers say about DEWALT Wire Wheel, Cable Twist, 4-Inch (DW4930)
I've been using a light welding jacket for a few months now, and I've been happy with it, especially the way the slivers get through the cotton.
I used this on my grinder to get some rust off of some piping that I needed to plug in and set up, but it took me a little longer to get it done because I needed toTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkiaTrademarkia
I used it to clean the metal after it was cut by a saw and to brush forged hardware to make it look better.
I tried the bristle type grinder brushes and they were very slow to work on, but I was glad I tried this product because it was the perfect wheel for the job.
These are a great product for cleaning up steel and concrete, and they are very easy to use.
Common Questions
Is it possible that this would work to remove paint from masonry?
I ended up ordering this without an answer to the question and found it to be great to remove paint from masonry.
Is a mandrel required to connect the wire wheel to the drill?
No, only connects to the threaded shaft of an angle grinder.
Can I use a drill to remove the dirt from the grout?
It would be a waste of time and money to use a length of allthread and washer and nut, and you would scar the tile.
How can you use it with a drill?
It's better to buy a drill chuck that's made to be used in a drill, rather than searching for one that can attach the wire brush to it.
Will this work with the DEWALT D28402K Small-Angle Grinder?
You remove the outer disk nut and thread it on, using the disk nut tool to make it loosen up when you need to change it.
Continue with Google
