Home > Air Compressors & Inflators > Makita MAC5200 3.0 HP Big Bore Air Compressor

Makita MAC5200 3.0 HP Big Bore Air Compressor

Cooler Running, Oil Lubrication, 3.0 Hp Big Bore Air Compressor, Power Rating:90 Psi, A Longer Working Life, Improved Performance, Hardwood Housing

8.9
8.9010
H&F Rating 485 reviews
All Buying Options
Add to Wishlist

Products Similar to Makita Air Compressors & Inflators

Results of our analysis:

We analyzed 206,385 reviews for 198 products in the Air Compressors & Inflators category.

We then analyzed 485 reviews for this product. None were recent.

Around 74% of reviews were positive and about 20% were negative.

Final Score:

8.94 out of 10, based on these factors:

  • Build quality
  • Customer support
  • Design
  • Maneuverability
  • Noise level
  • Overall performance
  • Power and energy efficiency
  • Size
  • Suction power
  • Value for money
  • What buyers say about Makita MAC5200 3.0 HP Big Bore Air Compressor


    After 30 days, I'm very happy with the quality of this compressor, it's sturdy, and it arrived within 3 business days of my order.


    I wanted to use a 3/8" hose and fitting as recommended by the manual, so I swapped one of the quick connects out for a 3/8" female with a 1/4" male thread.


    The new Makita is really nice, it's operation, quietness, design and compactness are all great.


    When it freezes, they leave enough water in the line to cause it to crack. This Makita MAC5200 does the job and saves me $100 every year.


    The compressor I have had for almost a decade has been reliable, and it has not had a single leak, failure, or issue since the wheels that affected older compressors were fixed.

    Common Questions

    Q:

    Does it cycle running a 1/2 inch impact wrench because of the small tank?

    A:

    I've used it for my flapper die grinder, doing a bit of wheel sanding on edges, but keeps up the pressure very well, quick recovery time.

    Q:

    Is it possible to change the female air couplings out for high flow couplings or are they not removeable?

    A:

    Yes. The compressor manifolds have two 1/4" female NPT connections, and this was very easy to replace.

    Q:

    Is it manufactured in China or Taiwan?

    A:

    The rear of the machine, it says, was made in taiwan.

    Q:

    Has anyone used this compressor with a plasma cutter?

    A:

    I use it with an Eastwood 40 cutter rated 5-7 CFM at 20-60 PSI and it works well. I haven't cut for lengthy periods(short cuts only,) the compressor runs a lot but it works.

    Q:

    I want to see if I can attach my hose reel with a U-bolt. What is the diameter of the frame tubing?

    A:

    I measured 1.4” on a nub and think it's accurate.

    Do you like this review?