Shark WANDVAC WV201BLBRN Cord-Free Handheld Vacuum, Cove
Taped Nozzle For Easy, Ultra-Lightweight And Balanced Hand Vacuum At Just 1.4 Lbs. For Maneuverability And Easy Cleaning., Brushless Motor., Unbelievable Suction Delivered By A High-Speed
What We Like
- Features tapered nozzle that absorbs large debris and fine dust easily
- Built-in LED light on control panel indicates charging status and remaining battery life
- Comes in lightweight design that offers quick maneuver and cleaning
Disadvantages
- Ordinary dust cup that may break easily
Results of our analysis:
We analyzed 149,868 reviews for 108 products in the Handheld Vacuum category.
We then analyzed 2,488 reviews for this product. Of these, 288 reviews were recent.
Around 71% of reviews were positive and about 23% were negative.
Final Score:

8.96 out of 10, based on these 15 factors:
What buyers say about Shark WANDVAC WV201BLBRN Cord-Free Handheld Vacuum, Cove
I plugged it in and let it fully charge, but then the battery went dead at least ten minutes after I tried it out.
If you still have issues with the device's sound quality, take it up with God, since God is the closest thing you're going to get to a singular entity who made sound so loud.
I was so excited to use it that I had to express my satisfaction, after picking up the cat litter with no effort at all, it even works great under the cabinets in the kitchen.
I like to suck up dust bunnies from under furniture and in corners, but it's easy to empty the canister, so I don't have to clean up all the time.
The filter gets too much gunk and I have had to clean it a lot.
Common Questions
Is it possible to use it on a single charge?
The Shark ION W1 Handheld Vacuum takes 2.5 hours to fully charge from empty and can run for approximately 9 minutes on a full charge.
Is it possible to easily replace the battery?
Call the number in the back of the booklet that comes with the vacuum to purchase a replacement battery.
Can you tell me what the voltage is?
The battery voltage for the Shark ION W1 Cordless Handheld Vacuum is 10.8 volts.
I hope I don't have to buy a new machine if I don't know where the filter is.
When you tap the button to empty the vacuum, you will see an area with an indentation that says to slide to access the filter.
Is it possible to leave the unit charging all the time or will it cause damage to the battery?
I was looking to ask the same question again, but I found the answer that made it convenient.